How To Use

When Applying

Ideally, a person should apply the cream rather than yourself when possible.

Treatment creams are applied directly to a dry scalp sparingly in the same manner. (The Reconditioner is applied to the hair.)
Section the hair thoroughly so that you can see the scalp, to identify any areas of inflammation, flaking or scaling. The treatment creams are applied using a small amount directly to these areas and only to these areas for the Juniper Scalp Cream, the TTR and Antioxidant can be used throughout the scalp.
Use a teaspoon (one supplied) to take out 1/2 to 1 teaspoon of cream which you can place onto the inside of the lid. Use this cream to dip in your finger to apply the cream, anywhere from 1-4 teaspoons of cream may be used at any one time depending on the treatment that is being carried out.

Do not place any cream back into the container as contamination may occur.

 

Reconditioning (optional with cream treatment)
Once you have applied the cream to all of the areas being treated then you may wish to add the Reconditioner. The Reconditioner is applied to the mid lengths and ends of the hair.
When using the reconditioner alone it is applied to the hair when dry, again tpo the mid lengths and ends only.
Once all creams have been applied leave on the head for 10-20 minuted, if you have a steamer it is ideal to steam the hair and scalp, if not using a steamer then a bath towel and shower cap to cover the head will suffice.
At the end of the treatment time wash the hair using the Juniper Scalp Therapy treatment shampoo twice (until the traces of cream have gone), followed by Juniper Scalp Therapy Conditioner.

You can now dry the hair as you would normally do.